Rubber Ring Joint (RRJ) Installation

---

     1 - Additional Tools Required

---

    2 - Wipe the inside of pipe (RRJ) as shown

---

    3 - Make sure it is clear of debris

---

    4 - Wipe the Rubber Ring Seal (RRS)

---

    5 - Fold the RRS as shown

---

    6 - Insert the RRS into groove

---

    7 - Adjust the RRJ to fit properly

---

    8 - Wipe the end of the adjoining pipe as shown

---

     9 - Measure the Depth of Insertion

---

    10 - Make a Marking line accordingly

---

    11 - Apply Lubricant onto the RRS evenly around

---

    12 - Recheck Lubrication Application

---

    13 - Apply Lubricant on the end of the adjoining pipe as shown

---

    14 - Insert the straight-end of the pipe into the RRJ

---

    15 - Bind the pipes separately as shown

---

    16 - Pull the Lever to achieve Full Insertion

---

    17 - Insert till the point of Marked line

---

    18 - Check the RRS to make sure it is in place

---

    19 - DO NOT use Crowbar as shown

---

    20 - Crowbar should be used with a wooden plank instead

---

    21 - Check the RRS again to make sure it is still in place

---

    22 - DO NOT use hammer as shown

---

    23 - Hammer should be used with a wooden plank instead

---